POS Terminals
      Back to home
      1. INTERNAL - Bepoz Help Guides
      2. Hardware
      3. POS Terminals

      Senor PicoPAD8 Mi Fare / RFID Setup

      Overview

      Summary

      Overview

      • There is a Senor Tablet that is based on the PicoPAD8 hardware. Within it, is a MiFare RFID reader.

      Prerequisites

      • The "HYUSB_PINPAD.dll" needs to be copied into the "Bepoz\\Programs folder" in order for the Device to register correctly when running SmartPOS.

      Step-by-step Guide

      • Login to Backoffice navigate to System Setup, Venue Stores and Tills

      • Select the Workstation/Till you would like to add a new device.

      • Right-click on the Workstation/Till and add new device -> Blank Device

      • Select Serial Data Input -> Senor Mi Fare 

      • Set Defaults 

      Additional Info

      Prefix Data: This simply prefixes the data sent with the characters in this field. Useful if the Card data has no prefix in it.
      Login Key: Only Needed if using the CardNumber Source of Read Sector. This must match how the Cards are Programmed. See your card supplier/programmer.
      Polling Speed: This determines how often the RFID is checked. Standard (100ms) should be fine.
      CardNumber Source: Select Card Serial Number or Read Sector. Read Sector needs other fields setup correctly, Serial Number does not need any other fields setup.
      Login Type: Only Needed if using the CardNumber Source of Read Sector. This must match how the Cards are Programmed. See your card supplier/programmer.
      Login Sector: Only Needed if using the CardNumber Source of Read Sector. This must match how the Cards are Programmed. See your card supplier/programmer.
      Read Block#: Only Needed if using the CardNumber Source of Read Sector. This must match how the Cards are Programmed. See your card supplier/programmer.